Applying 5th Regiment Northumberland Flag Transfers

By Victrix Limited 28mm miniatures | Published: 2026-10-26

Category: How-to Guides

Learn how to apply LBMS 5th Regiment Northumberland flag transfers to 28mm wargame banners with step-by-step instructions, common mistakes, and practical tips.

Quick Answer

To apply 5th Regiment Northumberland flag transfers to your 28mm wargame banners, prepare the surface, soak the transfer, slide it into place, and seal it with a matte varnish.

Why LBMS transfers are a good choice

LBMS transfers for the 5th Regiment 'Northumberland' are designed for 1/72nd scale but work well on 28mm miniatures. They come un-cut, which gives you more control during application and reduces the risk of tearing.

Because the transfers are un-cut, you can trim them to fit your banner shape precisely. This is especially useful if your wargame banner is slightly smaller or larger than the transfer itself.

Preparing your banner surface

A smooth, glossy surface is essential for a transfer to adhere properly. If your banner has a rough texture, apply a coat of gloss varnish and let it dry completely before starting.

Ensure the banner is clean and free of dust or grease. Any debris will create air bubbles and prevent the transfer from lying flat.

Step-by-step application process

Prepare the banner surface: Clean the banner and apply a coat of gloss varnish to create a smooth, non-porous surface. Let it dry completely. Check that the varnish is fully dry before moving on; a tacky surface will ruin the transfer.
Cut out the transfer: Trim the un-cut transfer close to the flag design, leaving a small margin of clear film to handle without touching the printed area. Cutting too close to the design can cause the edges to lift; leave at least 1mm of clear film.
Soak the transfer: Immerse the cut transfer in lukewarm water for 10-20 seconds until the backing paper slides freely. Remove and place on a flat surface. Do not soak too long or the transfer will become fragile and curl; test the edge with a fingertip.
Slide the transfer onto the banner: Position the transfer over the banner and gently slide it off the backing paper using a damp brush or tweezers. Adjust for correct alignment. Work quickly but carefully; once the transfer touches the surface, repositioning can tear it.
Smooth out air bubbles: Use a soft, damp cloth or cotton bud to gently roll from the center outward, pushing out any trapped air and excess water. Do not press too hard or the transfer may stretch; use light, even pressure.
Let it dry and seal: Allow the transfer to dry completely for at least 30 minutes. Then apply a coat of matte varnish to protect the transfer and blend it into the banner surface. Skipping the sealant will leave the transfer vulnerable to scratches and peeling during gaming.

Product facts

5th Regiment 'Northumberland': These LBMS transfers depict the flags of the 5th Regiment 'Northumberland' and come un-cut for easy application. The un-cut sheet lets you trim each flag to match your banner size, so you get a clean fit without excess film showing.
5th Regiment 'Northumberland'